Needing to set up center decode (also called picklist mode) on your Honeywell mobile computer? Center decode improves scanning accuracy by allowing only what is in the center of the scan beam's crosshairs to be scanned. This is especially helpful when barcodes are close together.
Our IT Specialist will show you step-by-step how to enable center decode on your Honeywell device!
Steps
- Open the App Drawer and tap on Settings.
- Scroll down to Honeywell Settings and tap on it.
- Select Scanning.
- Tap on Internal Scanner.
- Tap on Default Profile.
- Go to Decode Settings.
- Check the box for Center Decode.
- The setting is now applied.
Applicable Honeywell Models
These instructions work for the following Honeywell Android devices:
Leave a comment
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.